48
Fig. 14
The robot offers different cleaning modes which adapt to different cleaning needs.
Auto cleaning mode: From the Standby mode, press the On/off button on the robot or the
remote control for the robot to start cleaning automatically. It will carry out a cleaning cycle in
Gyro mode, Edge mode and then will nish off in Random mode. It is the most commonly used
cleaning mode and it is used to clean the 100 % of the house’s surface. The robot vacuums
the oor’s dust automatically, in and organized and efcient way, as it features memory and
gyroscopic navigation. Moreover, it changes direction when it nds obstacles through out its
route and it returns to the charging base in a smart and direct way once the cleaning is over.
It includes TotalCleanfunction, therefore the robot cleans the whole surface, returning to the
charging base if necessary until it nishes it.
Once it has completed cleaning, the robot will operate in Random mode until it runs out of
battery.
Edge mode
The display will show Mode 1, the robot will clean along the edges and will return to the
charging base through its smart technology once it has nished. If the robot has not started
cleaning from the charging base, it will return to the starting point.
Area mode
The display will show Mode 2 and the robot will clean a 2*2 m area.
Random mode
The display will show Mode 3, will start cleaning randomly.
Twice mode
The display will show Mode 4, the robot will carry out a whole cleaning cycle following the
next pattern: Gyro mode, Edge mode, Gyro mode and Edge mode again. When the cycle is
completed, it will return to the charging base with its smart technology.
Scrubbing mode
Press the Water intensity/Time settings button to enter the water-intensity mode and select
the desired intensity and select between 1, 2 or 3 (see Water intensity/Time settings section).
The display will show Mode 6. With this mode, the robot will carry out a cleaning cycle in Gyro
mode and in Edge mode, moving forward 2 metres and then backwards 1 metre consecutively,
simulating a real scrubbing movement. It will return to the charging base if necessary to nish
cleaning, and nally will return to the charging base when it runs out of battery. You can select
the desired water intensity level: high, medium or low.
Do not use the mop outdoors.
Remove the carpets before operating the robot under this mode.
During operation, control the water level on the Mix tan. Fill the tank when it is empty.
Remove the Wet & dry tank and the mop from the robot before charging it.
Note: in order to ensure perfect scrubbing, moisten the mop before starting scrubbing.
Gyro mode
The display will show Mode 5. When this mode is activated, the robot will carry out a whole
cleaning cycle in Gyro mode and then in Edge mode. Once it has nished, it will automatically
To Next Page
Loading...
