The schedule function does not
work
Make sure the main power switch on the bottom of robot is turned on.
Make sure the time, time of day (AM/PM), and the scheduled time have
been set correctly. Check if robot’s battery is too low to start cleaning.
Weak suction power
Check if any obstructions are blocking the suction inlet. Empty the dust
tank. Clean the filters with a vacuum cleaner or a cleaning brush. Check
if the filters are wet. Air-dry the filters completely before use.
The robot does not charge
Check if the indicator on the charging base are lighted up. If not, contact
the Technical Support Service of Cecotec. Clean the charging terminals
with a dry cloth. Check if the robot beeps when it gets to the charging
base. If not, contact the Technical Support Service of Cecotec.
The robot does not return to the
charging base
Remove objects within 3 ft/1 m to the left and right side and within 6 ft/2
m of the front of the charging base. The robot will return quicker to the
charging base when it is close to it. If the robot is far away from it, it will
take longer to detect it. Clean the charging terminals.
The main brush does not rotate Clean the main brush. Check if the main brush is properly installed.
The robot movements and routes
are usual.
Clean the sensors carefully with a dry cloth. Restart the robot by turning
the power switch off and on.
To Next Page
Loading...
