Cedar DID-4 - 6.1.2 Display and Elimination of Saved Measurement Data

15
it saves from the following memory number. Preservation of a maximum of 800 data can be performed,
and if it exceeds 800 data, it will be overwritten from No. 001. Since front data will disappear,
when exceeding 800 data, save them in a personal computer etc.
6.1.2 Display and Elimination of Saved Measurement Data
1. If the MEM key is pressed, it will be displayed
as "MEM", and the data number and measured value
which were saved at the end will be displayed by turns.
2. If UP key or DOWN key is pressed, a memory number is changed
and data can be searched.
If button operation is left for 6 seconds, the "MEM" display
will disappear and it will move to measurement mode.
* When memory data are eliminated individually
3. If the CLEAR key is pressed while displaying a memory number and
a torque value on alternation, it will blink .
4. If the CLEAR key is again pressed during blink, the data
which displayed as and were chosen will be eliminated.
(Subsequent data slide data to the eliminated portion)
5. If it is left during blink, it will be in the state
which can be measured. (Data are not eliminated)
* When the range is specified and memory data are eliminated
3. Press UP key or DOWN key and display the data of the beginning
of data to erase.
4. If the CLEAR key is pressed while displaying a memory number and
a torque value on alternation, it will blink .
5. Since a data number will increase if UPkey is pressed,
display the data of the last of the range to erase.
6. If the CLEAR key is pressed while displaying a memory number
and a torque value on alternation, the data of the range
which displayed as and was chosen will be eliminated.
If no button operations are carried out at this time,
it will check whether it blinks with and eliminates.
When eliminating, the CLEAR key is pressed during blink.
When stopping elimination, it is left as it is.
CLR Blink
Push CLEAR
Push CLEAR
When the data numbers 005-010 are eliminated
Push DOWN
Push CLEAR
CLR Blink
Push CLEAR
Data are eliminated
Data are eliminated
Push UP