18
The change of a setup is performed by the following methods.
1. In the state of a power source OFF, pressing the PRG key, press the ON/OFF key and switch on a power source.
2. If the PRG key is detached, it will be displayed as "01" or "00."
Since it will change if UP key is pressed, a setup is chosen.
3. If the PRG key is pressed again, after displaying it as , it returns to a torque display,
and will be in the state which can be measured.
7 System Reset
CPU in the tester might not start even if the battery charges it with
electricity complete discharged. (When not using it for a long term)
In that case, An AC/DC adaptor is connected and a system reset button is pushed.
It will be in an initial state (all the contents of memory are eliminated).
Do not use it excluding the following condition.
* When the display doesn't appear even if this machine is not used for a long term and charged.
* Additionally, when the tester doesn't work.
Since all the contents of memory are eliminated when system reset is performed, redo a setup once again.
8 Calibration Trust Service
8.1 Periodical calibration
A regular proofreading is necessary to manage the accuracy of torque tester.
By our company, the proofreading with the high reliability traced to the national standard is performed,
and in order to use it within accuracy, I recommend you one proofreading per year.
(Periodical calibration is a charge.)
An inspection report, a proofreading certificate, and traceability system figure attachment
8.2 Guarantee
Although manufactured under sufficient quality control, if the fault which originates in manufacture,
transportation, etc. of our company within one year after a purchase should occur,
I will fix this machine gratuitously.
In the following case, it becomes a charge within the term of a guarantee.
Failure and damage by the error, and unjust repair and reconstruction on use
Failure and damage by the natural disaster, pollution, unusual voltage, etc.
To Next Page
Loading...
