Cedima CF-2116 D - Replacing the Cutting Shaft V-Belts

ENGLISH
41
Maintenance and care
• CEDIMA
®
• Technical Documentation • All rights reserved as per ISO 16016 • Subject to modications due to progressive development •
5. Check the V-belt tension as described in section
4.2.5.
6. Mount the cover sheet over the V-belt tensioning
device at the fore of the V-belt cover (g. 4.4, 6.1 and
6.2).
6.6.3 Replacing the cutting shaft V-belts
The V-belts should or have to be replaced when further
tensioning is not possible any more and when the
V-belts are damaged (frayed, porous, …).
For replacing the 4 cutting shaft V-belts for the blade
drive proceed as follows:
1. Remove the cover sheet of the V-belt tensioning
device as described in section 6.6.2.
2. Dismount the cutting shaft cover, in case of right side
cutting, as described in section 4.5.4.
3. Dismount the blade guard and the saw blade in case
the CF-2116 D has been converted for left side cut-
ting (sections 4.5.3 and 4.5.4).
4. Lift the CF-2116 D (sections 4.3.1 and 4.3.2) until you
are able to loosen and remove the xing screw (size
17 mm) at the lower part of the cutting shaft V-belts’
protective cover (g. 6.3).
DANGER!
Maintenance works must only be carried
out when the joint cutter has been shut
down.
CF-2116 D, raised Fig. 6.3
Fixing screw cutting shaft V-belts’ protective cover
5. Loosen and remove the front xing screw (size 17
mm) at the cutting shaft V-belts’ protective cover (g.
6.3).
CF-2116 D, front (right) Fig. 6.4
xing screw cutting shaft V-belts’ protective cover
6. Loosen and remove the two rea4r xing screws (size
17 mm) at the cutting shaft V-belts’ protective cover
(g. 6.5).
7. Remove the cutting shaft V-belts’ protective cover
from the joint cutter (g. 5.6 and 5.7).
Lift the cutting shaft V-belts’ protective cover
carefully. Do not use any force!
CF-2116 D, left Fig. 6.5
cutting shaft V-belts’ protective cover xing screws