ENGLISH
53
Maintenance and care
• CEDIMA
®
• Technical Documentation • All rights reserved as per ISO 16016 • Subject to modications due to progressive development •
CF-2116 D front Fig. 6.31
CF-2116 D motor oil drain hose Fig. 6.32
4. For further maintenance works of the motor refer to
the motor operating manual.
6.6.17 Points of lubrication
DANGER!
Risk of injury! Switch OFF the joint cutter
engine! Secure the joint cutter against
unexpected starting or rolling away!
Handle the lubricants according to the
manufacturer’s instruction.
Apply corresponding grease (section 6.7) to the points
of lubrication as per maintenance table 6.5.
Grease the mechanical components of the control
elements (joints, bearings, …) and the movable compo-
nents such as blade guard, pointers and push rods.
Excessive greasing leads to early wear due to
adhering dust and cutting slurry.
To Next Page
Loading...
