USER’S MANUAL
7.3 Flashing New BIOS
Follow these steps to flash a new BIOS:
1. Create a bootable CD, copy the new BIOS image onto it, and insert it into
the CD-ROM drive.
2. Power on the system.
3. At the DOS prompt, enter the following:
AMIFLASH.EXE xxxxxxxx.fla /a/b/c
Where:
AMIFLASH.EXE is the flash utility program
xxxxxxxx.fla is the BIOS image filename
/a/b/c are modifiers to clear CMOS
4. Let the program run to completion without restarting or powering down the
system.
5. The program displays the prompt for restarting. Eject the CD and strike a
key to restart.
6. Verify that the BIOS is programmed correctly by checking the version
reported as the system begins POST.
7-4
To Next Page