If you do not see an image on your LCD screen, here are a few things to check:
1. Make sure the AC adapter is plugged in to an AC power source and attached to the microscope securely and
correctly.
2. Make sure you have the illuminators turned on with maximum brightness adjustment.
3. Make sure the objective lens you have chosen is set correctly and it has clicked in the right position.
4. Make sure that the diaphragm (filter wheel) is set correctly at a click position so that the illuminated light comes up
properly. The normal position is the 6 position (6 mm hole) for most applications.
5. 5. Make sure the specimen slide is correctly inserted into the clamp on the mechanical stage and properly
centered.
6. Make sure the SD card is inserted properly.
If icon does not display, then remove and insert again.
7. If the touch screen icons are not working properly, turn the microscope OFF and ON.
CARE, MAINTENANCE, AND WARRANTY
Your Celestron microscope is a precision optical instrument and should be treated with care at all times. Follow these
care and maintenance suggestions and your microscope will need very little maintenance throughout its lifetime.
When you are done using your microscope, remove any specimens left on the stage.
Turn off the illuminator switches.
Turn off the LCD monitor — push the on/off button until you see “Shutting Power Off.”
Unplug the power cord.
Always place the plastic bag or dust cover over the microscope when not in use to help keep it clean.
Store the microscope in a dry and clean place.
Be very careful if using your microscope in direct sunlight to prevent damage to the microscope or your eyes.
When moving your microscope, carry it by the “arm” with one hand and not by the focuser knob, LCD monitor, etc.
Then, put your other hand under the base for support.
Clean the outside surfaces (metal and plastic) with a moist cloth.
Always unplug any cords before cleaning.
Never clean optical surfaces with cloth or paper towels as they can scratch optical surfaces easily.
To clean optical surfaces, use an air blower or camel hair brush.
To clean fingerprints off of optical surfaces, use a lens cleaning agent and lens tissue available at most photo
outlets. When cleaning, do not rub in circles as this may cause streaks or scratches to occur.
Never disassemble or clean internal optical surfaces. This should be done by qualified technicians at the factory
or other authorized repair facilities.
When handling glass specimen slides, use care as the edges can be sharp
YOUR MICROSCOPE HAS A TWO YEAR LIMITED WARRANTY. FOR ASSISTANCE WITH THIS PRODUCT,
PLEASE VISIT CELESTRON’S ONLINE TECHNICAL SUPPORT CENTER AT
HTTPS://WWW.CELESTRON.COM/PAGES/TECHNICAL-SUPPORT. HERE, YOU MAY SEARCH THROUGH A
COMPREHENSIVE DATABASE OF FREQUENTLY ASKED QUESTIONS OR SUBMIT A REQUEST FOR
ASSISTANCE.
celestron.com
© 2019 Celestron • All rights reserved
celestron.com/pages/technical-support
To Next Page
Loading...
