Cellink INKREDIBLE - Specifications

10
The INKREDIBLE 3D bioprinter is a pneumac-based extrusion bioprinter with dual
printheads and UV LED curing system for bioprinng of complex human ssue models
and organs for ssue engineering research. It is a cost-eecve unit for innovators
to enter the 3D bioprinng eld and start bioprinng living ssues at ease. It can be
used as a standalone unit thanks to its LCD controller or it can be monitored through
a computer with the use of the accompanied soware. Your three-dimensional CAD
models are translated into coordinates and instrucons for the INKREDIBLE to allow the
bioprinter to move according to a dened path. The bioprinng process works through
the extrusion of a bioink or hydrogel biomaterial combined with human cells in a boom-
up, layer-by-layer fashion unl a 3D construct is built. Once the construct has been
bioprinted, it is crosslinked using the UV LED curing system or ionic soluons, depending
on your bioink’s crosslinking requirements.
2.1 Specicaons
2.1.1 Bioprinng
Bioprinng Technology: Pneumac-based microextrusion system
Printheads: 2 pneumac-based extrusion printheads.
1 UV LED curing system 365 nm (405 nm oponal)
Build Volume: 130 x 80 x 50 mm. Printbed has Insets for P100 petri dish and mul-
well plates
Posioning Precision: XY: 10 µm [0.0004 in]; Z: 2.5 µm [0.0001 in]
Layer Resoluon: 100 µm [0.0039 in]
Hydrogel’s viscosity range: 0.001 to 250 Pa.S [1 to 250,000 cP]
Max. Operang Pressure: 700 kPa
Set Pressure Range: 5 to 400 kPa
Sensivity: Within 0.2% F.S. (0.8 kPa)
Repeatability: Within ±1% F.S. (4 kPa)
Minimum Unit Seng: 1 kPa
Pressure Display Units: kPa, MPa, kgf/cm
2
, bar, psi, inHg and mmHg
Printhead’s Response Time: 5 ms or less (ON), 4 ms or less (OFF)
Nozzle Length: Auto-calibraon, 6.35 mm [0.25 in] to 38.1 mm [1.5 in]
Nozzle Diameter: User dependent, 50 to 1540 µm