Cellink INKREDIBLE - Starting a Print

25
5.2.5 Starng the print:
1. The INKREDIBLE 3D Bioprinter is now ready to bioprint! Start by inserng your SD-
card, containing the 3D model you want to print, into the SD-card reader [6].
2. In the menu, turn the control knob [8] to “Bioprint” and press to enter. If the “Bioprint”
opon does not show up in the menu, control that your SD-card is properly inserted
and use the control knob [8] to select “Reload SD-card”. This should make the “Bioprint”
opon available in the menu.
3. Use the control knob [8] to select the model you wish to print and push to
start the bioprinng process.
The bioprinng process is now running! The pressure can be adjusted during bioprinng
process in order to have connuous ow, simply turn the pressure regulators [11a] and
[11b]. Once the bioprinng process is completed the printbed will lower.
WARNING! The INKREDIBLE 3D Bioprinter includes moving parts that can
cause injury. Never reach inside the INKREDIBLE while it is in operaon.
Always allow the INKREDIBLE 3D Bioprinter to come to a complete stop
prior to reaching inside.
CAUTION! Never leave the INKREDIBLE 3D Bioprinter unaended during
operaon!
You can try bioprinng any of your bioinks or hydrogels. Simply, load it in the cartridges
and congure your bioprinng parameters (prinng pressure and prinng speed).
Conguraons, pressure adjustments, and any development of printable biomaterial is
your responsibility. CELLINK is not responsible for any clogging or damages caused by
any user-dependent biomaterial bioprinted with your INKREDIBLE 3D Bioprinter.