Cellink INKREDIBLE - General Safety Information

6
WARNING! This symbol will indicate if there is risk of personal injury.
CAUTION! This symbol will indicate if there is risk of causing damage to your
INKREDIBLE 3D Bioprinter or other equipment.
Before you start using your INKREDIBLE 3D bioprinter, please take me to review the
enre manual. Maloperaon of the INKREDIBLE 3D bioprinter instrument can lead to
severe and irreversible injuries if the safety instrucons are not followed. Throughout the
manual we will use the following two symbols to indicate if there is risk for equipment
damage or personal injury:
In order to respond to the INKREDIBLE 3D Bioprinter and its relevant security
requirements, the instrument has to be operated by trained personnel, who are aware
of the risks and dangers that can be induced to themselves, as well as for the sta
being in close proximity with the INKREDIBLE 3D Bioprinter. The sta being involved
in the installaon, or the maintenance of the system or a part of the system, has to be
qualied through appropriate training. Use the instrument only for its intended purpose
as described in the documentaon. Do not modify the instrument, sub-components or
accessories.
1.1 General safety informaon
WARNING! Never reach into the instrument unl all components of the instrument
have come to a complete stop. Moving parts can cause serious injuries.
WARNING! Before cleaning, inspecng, adjusng, repairing or disassembling the
instrument or the dispensing units, stop the instrument, turn o the main switch
and disconnect if from its electrical power source.
WARNING! The INKREDIBLE 3D Bioprinter is ed with a 365nm (405nm
oponal) UV LED. Do not look directly at the light source. Always wear protecve
gear when operang the system, including UV protecve goggles.
WARNING! Improper mounted pressurized air spouts, liquid spouts or cartridges
can be dangerous. Verify that all connecons are properly connected and all
components are specied for use with the intended pressure. Verify that the
supplied air pressure does not exceed 400 kPa.
In addion to the manual, we are connously uploading instrucon videos on our
YouTube-channel, CELLINK3D. To access it go to:
hp://ny.cc/rbz7xy