19
122. From the
“Administrator”
screen, use the
arrow keys to select
“Computer Settings.”
123. If required, enter either
the previous address
or a new IP address
(if connected to a
network).
124. To enter an IP address,
press the right arrow
key to select the initial
set of numbers of the
address. Use the up
and/or down arrow
keys to increase
or decrease the
number. Repeat these
procedures for each
of the set of numbers
to complete the IP
address.
125. Once the IP address is
entered properly, press
the “Accept” key.
126. On each of the two
instruments, enter a
method and press the
“Tare” key to ensure
that each instrument is
communicating with the
balance.
Contrast
127. From the
“Administrator”
screen, use the
arrow keys to select
“Contrast.”
128. Using the arrow keys,
adjust the contrast of
the instrument screen
as desired.
129. Press the “Accept” key.
To Next Page
Loading...
Need help?
General
