CEM SPRINT - System Information

only once upon system
installation.
“Prepare to Ship”
removes fl uids from
the instrument. This
function must always
be performed prior to
instrument relocation
or repair. Refer to the
“Maintenance, Trouble-
shooting and Service”
section of this manual.
st
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
ru
ru
ru
ru
ru
ru
ru
ru
ru
ru
ru
ru
ru
ru
ru
ru
ru
ru
ru
ru
r
ru
u
u
u
ru
ru
r
ru
r
ru
u
ru
ru
ru
r
r
ru
r
ru
u
ru
r
ru
ru
r
ru
u
ru
r
ru
ru
u
u
ru
u
u
r
r
u
u
u
ru
u
r
u
u
ru
r
r
u
ru
r
r
ru
u
ru
u
r
ru
ru
ru
r
ru
u
u
u
u
ru
ru
u
u
ru
u
r
ru
r
u
ru
r
r
ru
ru
ru
r
oca
r
r
r
r
r
r
r
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
30
System Information
1. From the Main Screen,
using the arrow keys,
select “Setup” and
press the “Enter” key.
2. From the “Settings”
screen, select “Sys-
tem Information” and
press the “Enter” key.
Note: The “System Infor-
mation” screens are for the
user’s information and CEM
Service Specialists only.
System Information catego-
ries include:
“System” - provides
information such as
the instrument serial
number, IP address,
software version, etc.
“Service” - provides
system component run
times.
“Calibration” provides
the calibration date of
the heater RTD, heater
sensor, and sample.
“Turntable Counts”
- provides turntable
information.
“Z Axis Counts” -
provides information
pertaining to the Z axis
movements.
“Current Balance” -
provides the current
balance information.
“RTD” - Provides the
heater RTD slope and Y
intercept.
“Sensor” - provides
the thresholds of the
system sensors.
“Clock” - provides the
setup of the instrument
clock.