Seat
The initial design status is shown in the
figure.
Adjust the front and rear position of the
seat: pull up the seat position adjusting
rod ① , slide the seat to the desired
position, and then release the adjusting
rod.
Adjust the seat back angle: pull up the
seat back angle adjusting handle ② ,
and use the back pressure to tilt the
seat back forwards or backwards. After
adjusting the seat back to the desired
position, release the handle.
• It is forbidden to adjust the seat during driving, otherwise the seat may move
unexpectedly, causing the driver to lose control of the vehicle.
• It is forbidden to tilt the seat back excessively, otherwise the lap belt portion
of the safety belt may slip over the hips and directly strangle the abdomen,
or the shoulder belt portion of the safety belt may touch the neck, thus
increasing the risk of serious injury or even endangering life in the event of
an accident.
• Make sure there is enough space for the feet to avoid being pinched.
• Do not put your hands under the seat or near moving parts and components
to avoid being pinched.
To Next Page
Loading...