EasyManua.ls Logo

CENNTRO TeeMak - Dumping Device

Default Icon
102 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3
Operation
52
Operation
Dumping Device*
After the vehicle starts, press the
dumping device switch to operate
the dumping bucket to rise and fall,
so as to facilitate cargo loading and
unloading.
Road requirements for dumping process: it must be on a hard and flat road.
Loading requirements: the load shall be evenly distributed in the dumping
bucket, and shall not be deviated forward, backward or to one side.
Vehicle driving: It is strictly forbidden to go downhill at high speed with full
load and suddenly brake. The turning speed should be less than 15km/h.
During lifting, it is strictly forbidden to stretch your head and hand into the
space below the dumping bucket.
In the process of dumping operation, after the dumping bucket is lifted to
the top position and reset, it is necessary to immediately return the operating
switch to the original position, otherwise the dumping motor may be burnt.