OPERATING INSTRUCTIONS
To Raise And Lower The 10" Saw Blade:
1. When cutting, the top edge of the Saw Blade (part #14-I) should rise about 1/4”
above the top edge of the workpiece.
2. To raise the height of the 10" Saw Blade (part #14-I), unlock the Bevel Lock (part
#19-I). Next, turn the Height Handle (part #5G) clockwise until the desired height
is acquired. Then, re-lock the Bevel Lock.
(See Figures B, M, and Assy. Diagrams G, and I.)
3. To lower the height of the 10" Saw Blade (part #14-I), unlock the Bevel Lock (part
#19-I). Next, turn the Height Handle (part #5G) counterclockwise until the
desired height is acquired. Then, re-lock the Bevel Lock.
(See Figures, B, M, and Assy. Diagrams G, and I.)
To Adjust The Width Of A Cut:
1. The width of a cut is achieved by moving the Rip Fence (part #10C) to the right
or left. (See Figures B, L, and Assy. Diagram C.)
2. The 10" Table Saw features a Scale (part #6H) on the Front Rail (part #7H) of the
unit. The Scale’s measurements are in inch increments.
(See Figures B, H, L, and Assy. Diagrams C, and H.)
3. To position the Rip Fence (part #10C) for the desired width of a cut, unlock the
Rip Fence Handle (part #37C) by raising it upward.
(See Figures B, L, and Assy. Diagrams, C, and H.)
4. Place the workpiece on the Saw Table (part #17H) against the Rip Fence (part
#10C). Next, slide the workpiece, and the Rip Fence, to the right or left until the
left side of the Scale (part #6H) indicates on the Scale Indicator (part #20C) the
desired width to be cut. Then, lock the Rip Fence in place by lowering the Rip
Fence Handle (part #37C). (See Figures B, L, and Assy. Diagrams C, and H.)
To Adjust The Bevel Of The 10" Saw Blade:
1. The 10" Table Saw is capable of making bevel cuts from 90 degrees to 45
degrees.
2. The 10" Table Saw also features a Bevel Scale (part #10G) on the front side of
the unit. (See Figure B, and Assy. Diagram G.)
SKU 46813 PAGE 23
To Next Page
Loading...
