Central Machinery 96549 - Starting the Engine; Stopping the Engine

Page 8SKU 96549
For technical questions, please call 1-800-444-3353.
Starting the Engine
During this procedure, it may be helpful to refer to the photos of the Engine Controls on
page 6.
Push the Gas Valve to the open (right) position.
Close the Choke (15F) by pulling it to the left.
Note: If the Engine is already hot, it is not necessary to close the Choke.
Push the Throttle Lever (18F) to the slow (right) position , then move
it back slightly.
Turn the Engine Switch (6K) to the On position.
Gently pull the Pull Cord Handle (16K) until it engages. Then pull it hard and all the
way out. Slowly guide the Pull Cord back into the starter.
The Engine should start. Try again if it does not start. Refer to the Troubleshooting
section if problems persist. Let the engine run for five minutes to warm up.
Push the Choke to the right
Push the Throttle Lever to the fast position (left).
Stopping the Engine
Push the Throttle Lever to the slow (right) position.
Turn the Engine Switch to the Off position.
Push the Gas Valve to the closed (left) position.
1.
2.
3.
4.
5.
6.
7.
1.
2.
3.