Centurion SDO4 SMART - Page 40

page 40 www.centsys.com
FIGURE 73
FIGURE 74
FIGURE 75
Once aligned, secure them into
position using two supplied
hexagonal head ange nuts and
bolts: one set through the bottom
hole of the straight towing arm,
and the other through the top hole
of the bent towing arm.
The two towing arms must
be joined in such a way
that they are just short of
parallel to the garage door
and the ceiling.
Angle ‘Z’ should be ±80°
when the garage door
is in the closed position,
as shown in Figure 73.
This will put less strain
on the motor on start-up
and, furthermore, aid in
preventing the garage door
from being forced open by
hand.
The SDO4 SMART is now
installed and ready for
programming.
Please do not forget to ax
the safety sticker and tag.
Warning Sticker Tag
Z
SDO4 SMART
Straight
towing arm
Bent
towing
arm
Straight
towing arm
Bent towing
arm
M8 Flange
nuts
M8x20
Flange
bolts
OPERATOR INSTALLATION - TIP-UP DOORSSECTION 6