page 7 www.centsys.com
• Repairs to the garage door must be carried out by technically qualied persons.
Attempting to repair the garage door without suitable technical qualication may
result in severe personal injury, death and / or property damage
• Where possible, install the SDO4 SMART at least two meters or more above the
ground. Adjust the engage / disengage cord so that it hangs approximately 1.8
meters from the ground
• The header bracket carries ALL of the opening and closing thrust of the SDO4 SMART
and as such must be securely fastened to a rigid, structural member of the garage
wall or ceiling. It is entirely up to the installer to determine the xing method and
the structural suitability of the xing points
• The engage / disengage instruction tag must remain attached to the engage /
disengage cord
• Locate the wall switch;
• Within site of the garage door, and
• At a minimum height of 1.5 meters above the ground so that it remains out of
the reach of small children, and
• Away from all moving parts of the garage door
• The entrapment warning label must be secured in a prominent position adjacent to
the wall switch
• Do not connect the SDO4 SMART to the power outlet until this manual instructs you
to do so
• Subsequent to installation and adjustment, the SDO4 SMART must stop and reverse
direction when it comes into contact with a 40mm high solid object placed on the
oor under the garage door
• The correct function of the safety obstruction force system should be checked on a
monthly basis
• Never use the SDO4 SMART unless the garage door is in full view and free from any
object which may impede the movement of the garage door such as cars, children
and / or adults
• Never allow children to operate the SDO4 SMART
• Never operate the SDO4 SMART when any persons are under or near the path of the
garage door. Children must be supervised at all times when near the garage door and
when the SDO4 SMART is in use
• Never attempt to disengage the SDO4 SMART to manual operation when there are
children/ persons and / or solid objects including motor vehicles under or near the
path of the garage door as the garage door may fall sharply upon Manual Release
from the SDO4 SMART
• Never attempt to open or close the garage door by pulling on the engage / disengage
cord
• Never attempt to make any repairs or remove covers from the SDO4 SMART without
rst disconnecting the power supply cord from the main power supply
• Removal of the SDO4 SMART’s protective covers must only be performed by a
technically qualied person. Attempting to remove the protective covers or repair the
SDO4 SMART without suitable technical qualication may result in severe personal
injury, death and/or property damage
• Install the actuating member for the manual release at a height less than 1,8m
• Install any xed control at a height of at least 1,5m and within sight of the door but
away from moving parts
IMPORTANT SAFETY INFORMATIONSECTION 1
To Next Page
Loading...
