Centurion SDO4 SMART - Page 8

page 8 www.centsys.com
• For additional safety, we strongly recommend the inclusion of safety beams.
Although the SDO4 SMART incorporates a pressure sensitive safety obstruction force
system, the addition of safety beams will greatly enhance the operating safety of an
automatic garage door and provide additional peace of mind. In some countries,
it is a mandate of law to t safety beams. It is the sole responsibility of the owner /
installer to t safety beams in those countries that so require
• Always ensure that the garage door is fully open and stationary before driving in or
out of the garage
• Always ensure the garage door is fully closed and stationary before moving out of its
view
• Adjustments to the safety stop / reverse force settings must only be carried out by
a technically qualied person. Attempting to adjust the settings without suitable
technical qualication may result in severe personal injury, death and / or property
damage
• Keep hands and loose clothing clear of the SDO4 SMART and garage door at all
times
• In order for the safety obstruction force system to function, it must rst encounter
an obstruction in the form of an object / person onto which some force MUST
be exerted. As a result, the object / person / garage door may suer DAMAGE
AND / OR INJURY
• The safety obstruction system is designed to work on STATIONARY objects only.
Serious personal injury, death and / or property damage may occur if the garage door
comes into contact with a moving object during an open or close cycle
• Keep remote controls away from children
• Take care when operating the manual release since an open door may fall rapidly due
to weak or broken springs or being out of balance
• Each month check that the drive reverses when the door contacts a 40 mm high
object placed on the oor. Adjust if necessary and recheck since an incorrect
adjustment may present a hazard
• Permanently x the labels warning against entrapment in a prominent place or near
any xed controls
• Permanently x the label concerning the manual release adjacent to its actuating
member
• After installation, ensure that
the mechanism is properly
adjusted and that the drive
reverses when the door contacts
a 40 mm high object placed on
the oor
• The drive must not be used with
a door incorporating a wicket
door (unless the drive cannot
be operated with the wicket
door open)
• After installation, ensure that
parts of the door do not extend
over public foot paths or roads
WARNING! WARNING! WARNING! WARNING! WARNING!
A MOVING GARAGE DOOR CAN CAUSE
SERIOUS INJURY OR DEATH
KEEP CLEAR! DOOR MAY MOVE AT ANY TIME!
DO NOT ALLOW CHILDREN TO PLAY IN THE AREA
OR OPERATE THE DOOR.
KEEP CLEAR!
DOOR MAY MOVE AT ANY TIME!
SAFETY
FIRST
IMPORTANT SAFETY INFORMATIONSECTION 1