Centurion VECTOR2 - Page 34

Trouble-
shooting
guide
page 30
Symptom
Cause
Action
Gate does not
autoclose.

Infrared beam(s) (if
fitted) is(are) faulty

Check that the auto-
close override facility
is not being operated

Check that the GREEN
LEDs adjacent the ‘Safe
CLS’ and ‘Safe OPN’
inputs are ON when the
infrared beams are clear

Check that beam is
correctly aligned. It
should be possible to hear
the relay within the
‘receiver’ side of the
infrared beam ‘click’ as
the beam is broken and
cleared

Ensure that nobody is
mistakenly pressing and
holding down the gate-
release pushbutton on,
either the remote, or
intercom for too long
when activating the unit.
Refer section Autoclose
Override
Gate starts closing
but stops and re-
opens.

Check the GREEN ‘Safe
CLS’ LED on controller. It
must remain ON if beam
is clear

Consult your installer if
there is a problem

Disconnect the VECTOR2
from the gate by remov-
ing the pin from the gate
bracket. Check that the
operator runs correctly
when not loaded by the
gate. Consult your
installer if there is a
problem

Intermittent operation
of infrared beam if
fitted

Anti-crushing device
is set too sensitively
Operator drives
too far and does
not stop in the
correct open and
closed positions.

Origin system not
functioning correctly

Origin position has
been shifted

Check that the cables
from the VECTOR2
actuator are terminated
correctly and making
good contact. Consult
your installer should there
be a problem