3. Warranty and Safety Conditions
*
WARNING:
The electronics in the power supply system are designed for an indoor, clean environment.
When installed in a dusty and/or corrosive environment, outdoor or indoor, it is important to:
Install an appropriate filter on the enclosure door, or on the room’s air conditioning system
Keep the enclosure door closed during operation
Replace the filters on a regular basis.
Important Safety Instructions and Save These Instructions.
3.1 Disclaimer
The manufacturer declines all responsibilities if equipment is not installed, used or operated according to the instructions
herein by skilled technicians according to local regulations.
Warranty does not apply if the product is not installed, used and handled according to the instructions in the manuals.
3.2 Technical care
This electric equipment can only be repaired or maintained by a “qualified employee” with adequate training. Even
personnel who are in charge of simple repairs or maintenance are required to have knowledge or experience related to
electrical maintenance.
Please follow the procedures contained in this Manual, and note all the “DANGER”, “WARNING” AND “NOTICE” marks
contained in this manual. Warning labels must not be removed.
Qualified employees are trained to recognize and avoid any dangers that might be present when working on or near
exposed electrical parts.
Qualified employees should know how to lock out and tag out machines, so the machines will not accidentally be turned
on and injure employees working on them.
Qualified employees also should understand safety related work practices, including those by OSHA and NFPA, as well as
knowing what personal protective equipment should be worn.
All operators are to be trained to perform the emergency shut-down procedure.
This product is intended to be installed only in a restricted access area as defined by UL 60950 and in accordance with the
National Electrical Code ANSI/NFPA 70, or equivalent local agencies.
Maximum operating ambient temperature is 40°C (104°F).
This unit is intended for installation in a temperature-regulated, indoor area that is relatively free of conductive
contaminants.
Never wear metallic objects such as rings, watches, or bracelets during installation, service or maintenance of the product.
This product is suitable for use in a computer room.
* These instructions are valid for most CE+T Products/Systems. Some points might however not be valid for the product
described in this manual
7 – Monitoring – User manual – v1.2
Warranty and Safety Conditions
To Next Page
Loading...