4-44
4E CONTACTOR CLOSED
Condition for error detection
Alarm not used in pump configuration.
Verify:
- the presence of +Vb on pin 1 and 4 connector JP
5A CHOPPER NOT CONF - UNUSED
5B STEER WIRE KO
Condition for error detection
Alarm not used in pump configuration.
Verify:
- the presence of +Vb on pin 1 and 4 connector JP
5C DATA ACQUISITION
Condition for error detection
This warning comunicates that the logic is in current acquisition phase.
In this phase the logic doesn't work.
• Reset the logic unit using the RESET function
• Repeat all acquisitions
• Update the logic unit to the latest version of the software via the PROGRAMMER
• If the alarm persists after the key reset, replace the logic unit.
https://www.forkliftpdfmanuals.com/
To Next Page
