Cessna T188C - Page 35

MODEL
188
& T188
SERIES
SERVICE
MANUAL
HYDRAULIC
FLUID:
SPEC.
NO. MIL-H-5606
SPECIFIED
AVIATION
GRADE
FUELS:
WARNING
ONLY
AVIATION
GRADE
FUELS
ARE
APPROVED
FOR USE.
ENGINE
MODEL
APPROVED
FUEL
GRADES
NOTE
CONTINENTAL 0-470 100LL (blue)
CONTINENTAL
I0-520
100 (green) (formerly 100/130) 1
NOTE
1. Compliance
with Continental Aircraft
Engine Service Bulletins
M77-3 and M75-2,
and all
supplements or revisions
thereto,
must be accomplished.
SPECIFIED AVIATION GRADE OIL:
AVERAGE
AMBIENT
TEMPERATURE
(°F)
/
OIL GRADE
0
°
100 20
°
30
40
50
°
60
°
70
°
80
°
90
SAE 30 SAE 50
4
SAE 15W-50
SAE
20W-50
SAE 25W
SAE 25W-60 --
Aviation grade ashless
dispersant oil, conforming
to Continental Motors
Specification
MHS-24,
and all
revisions
or supplements
thereto,
must be used
except as
noted in
paragraph
2-21
herein. Refer
to Continental
Aircraft
Engine Service
Bulletin
M75-2
and any superseding
bulletins, revisions
or supplements thereto,
for further recom-
mendations.
Oil capacities
for the aircraft are given
in the following chart.
To minimize loss
of
oil through the breather,
fill to specified
oil level on dipstick for
normal operation
(flight
of less than
three hours
duration).
For extended
flight, fill
to FULL
mark on
dipstick. Do not
operate with less than
MINIMUM FOR FLIGHT
quantities listed. If
an
external oil
filter is Installed,
one
additional
quart of oil
is required
when filter
is changed.
CAPACITY
CAPACITY
(TOTAL
NORMAL
MINIMUM
(TOTAL)
WITH
FILTER)
OPERATION
FOR
FLIGHT
12
13
10
9
Figure
2-4. Servicing
(Sheet
2 of 5)
Revision 1 2-13