Cessna T188C - Page 45

MODEL 188 & T188 SERIES SERVICE MANUAL
IMPORTANT
SPECIAL
INSPECTION
ITEM
READ ALL INSPECTION REQUIREMENTS
EACH
200 HOURS
PARAGRAPHS
PRIOR TO USING
THESE EACH 100
HOURS
CHARTS.
EACH 50 HOURS
PROPELLER
1. Spinner ......................................................................
2. Spinner
bulkhead ............................
..................................
3. Blades
.......................................................................
4.
Bolts and/or nuts ...............................................................
5. Hub ..........................................................................
6. Governor
and control ...........................................................
ENGINE COMPARTMENT
Check for evidence
of oil and fuel leaks, then clean entire
engine and compartment,
if needed, prior to inspection.
1. Engine oil, screen, filler cap, dipstick, drain plug and external filter element .............
2. Oil cooler ....................................................................
3. Induction air filter...............................................................
4. Induction airbox, air valves, doors and controls .....................................
5. Cold and hot air hoses ..........................................................
6. Engine baffles ................................................... ............
7. Cylinders, rocker
box covers and push rod housings ................................
8. Crankcase,
oil sump,
accessory section and
front crankshaft
seal.....................
9. Hoses, metal
lines and fittings ...................................................
10. Intake and exhaust systems
.....................................................
11.
Ignition harness ................................................................
12. Spark plugs ...................................................................
13. Compression check ............................................................
14. Crankcase
and breather lines ....................................................
15. Electrical wiring ................................................................
16.
Engine controls and linkage .....................................................
17. Engine shock mounts,
mount structure and ground straps
...........................
18. Cabin heat valves, doors and controls
.............................................
19. Starter,
solenoid and electrical connections ........................................
20.
Starter brushes, brush leads and commutator
......................................
S
*
16
S
*
*
.
1
.
.
2
.
.
.
*
*
*
*
3
4
S
*
*
*
.
.
6
*
*
.
.
2-23