FY –33VC Operation manual
- 10 -
4. Requirement for computer
In order to avoid problems caused by computer, please choose high quality computer or brand
computer such as DELL or IBM, etc.
3.3 Port of Printer
USB 2.0
Connect printer’s USB and computer’s USB directly.
Find driver for USB at UsbInstalFile/Try Setup under printer’s driver.
3.4 Connect With Power
1， After all the parts installed, move printer to its working area and clean up the package.
2， Connect power cables, including power for printer and heater, printing data cable. Protective
switch only works for heater’s power. Usually this switch should be at status of On (switch on
above, far from red point)
3， After finishing, turn on power. The Auto-ink-supply-system runs to pump ink from main ink
bottles to Sub ink bottles.
4， Feed in media and printer enters waiting status.
5， Then go in test printing. Observe ink drop. If not good, clean print head again.
To Next Page
Loading...