FY –33VC Operation manual
- 34 -
In these menus, most important is print setting.
11.2.2 Print Setting
This function is to set the printing parameter, print mode, uni-direction, BID and the color of ink.
Note: Usually the four colors should all be selected. Only when the engineer adjusts the
position of head, one certain color is chosen to modify the printing parameter.
Print Mode：
There are 7 modes for choosing: Test mode, 200 2Pass, 200 4-2Pass, 200 3Pass, 200 6-3Pass, 200
4Pass, 400 DPI
Explanation:
Test mode: Just 200 1Pass. 200dpi of horizontal resolution and print once at feeding
direction
200 2Pass: 200dpi of horizontal resolution and print twice at feeding direction. Ink volume
is twice of 200 1Pass, but printing speed is just 1/2.
200 4-2Pass: print quarter under half of 200dpi for horizontal resolution and involving twice
at feeding direction. Ink volume is twice of 200 1Pass, but printing speed is
just 1/2.
200 3Pass： 200dpi of horizontal resolution and price thrice at feeding direction. Ink
volume is 3 times of 200 1Pass but printing speed is 1/3 of 200 1Pass.
200 6-3Pass: print six times under half of 200dpi for horizontal resolution and involving
twice at feeding direction. Ink volume is twice of 200 1Pass, but printing
speed is just 1/2 of 200 3Pass.
200 4Pass： 200dpi of horizontal resolution and print 4 times at feeding direction. Ink
volume is 4 times of 200 1Pass and printing speed is 1/4 of 200 1Pass.
400 DPI： Just 400 4-2Pass. 200dpi of horizontal resolution and print 4 times, so
horizontal printing resolution is 400dpi. Printing twice at feeding direction. Ink
volume is 4 times of 200 1Pass and printing speed is 1/2 of 400 2Pass.
11.2.3 Printer Parameter Setting
Pressing “Printing parameter setting”, it shows warning as below:
To Next Page
Loading...