28
USING THE DOOR CONTROL
SYNCHRONIZETHEDOORCONTROL
To synchronize the door control to the garage door opener, pressthe push bar until the garage door
opener activates(it may take up to 3 presses).Testthe door control by pressing the push bar,each
press ofthe push bar will activate the garage door opener.
Push Bar
LIGHT Button
SERVICE LED
LOCK Button
COMMAND LED
LEARN Button
PUSH BAR
Press the push bar to open or close the door.
LIGHT BUTTON
Press the LIGHTbutton to turn the garage door opener lights on or off.When the lights are turned on
they will stay on until the LIGHT button ispressed again, or until the garage door opener isactivated.
Once the garage door opener isactivated the lights will turn offafter the specified period of time (the
factory setting is 4-1/2 minutes). The LIGHT button will not control the lights when the door is in motion.
The following features are accessible by lifting upthe push bar:
LEARN A DEVICE
Any compatible remote controls, wireless keyless entry, or MyQ
®
accessoriescan be programmed to
the garage door opener by pressing the LEARN button the door control,see page 30.
LOCK
The LOCK feature is designed to preventactivation of the garage door opener from remote controls
while still allowing activation from the door control and keyless entry.This feature is useful for added
peace ofmind when the home is empty (i.e. vacation).
AUTOMATIC LIGHT
Light Feature
The lights will turn on when someone enters through the open garage door and the safetyreversing
sensor infrared beam is broken.
MAINTENANCE ALERT (MAS)
This feature assists the homeowner in ensuring the garage door opener system staysin good working
condition. When the garage door opener needsto be serviced (approximately4500 garage door
opener cycles) the command (yellow) and service (red) LEDs will begin to alternately flash backand
forth. The factory setting for the MASfeature is off and can be activated at time of installation. Contact
your installing dealer for service.
Door Control
To Next Page
Loading...
