Chamberlain 8355 - Control Panel Setup

29
Control Panel Setup
LOCK
NOTE: Your remote controls will NOTwork
when LOCK mode is active however your
keyless entry will still allow access to your
garage.
Activate: Pressand hold the LOCK button for
2 seconds.The command LEDwill flash as long
as the lock feature is activated and your
handheld remote control will not operate your
door at this time.
Deactivate: Press and hold the LOCK button
again for 2 seconds.The command LEDwill
stop flashing and normal operation will resume.
LOCK Button
Command LED
LIGHT
To change the amount of time the garage dooropener lights will stay on:
Press and hold the LOCK button until the garage door opener lights flash.* The time interval is
indicated by the number of flashes.
Number of times garage door opener lights flash Time the garage door opener light stays on
1 1 1/2 Minutes
2 2 1/2 Minutes
3 3 1/2 Minutes
4 4 1/2 Minutes
To cycle through the time intervals repeatthe step above.
LIGHTFEATURE (Default is Active)
Deactivate:
Press and hold the LIGHTbutton until the garage door opener lightsturn on, then offagain.*
Activate:
Startwith the garage door opener lights on. Press and hold the LIGHT button until the garage door
opener lightsturn off, then on again.*
NOTE: If the command LEDis continuously blinking, the LOCKfeature needs to be deactivated.
LOCK Button
LIGHT Button
Command
LED
* Approximately 10 seconds
MAINTENANCEALERT
SYSTEM (MAS):
Activate/Deactivate
Press and hold the LEARNbutton. Then press
the LIGHTbutton.The service LEDwill flash
the status;Active is 2 flashesand deactivated
is 3 flashes.
LEARN
Button
LIGHT
Button
Service
LED
Door Control