Chamberlain 8355 - Erase Remote Control Memory

31
To Erase the Memory
ERASE ALL REMOTE CONTROLS AND KEYLESS ENTRIES
1 Pressand hold the learn button on garage door opener until the learn LED goes out
(approximately 6 seconds).All remote control and keyless entry codes are now erased.
Reprogram any accessoryyou wish to use.
ERASE ALL DEVICES (Including MyQ
®
enabled accessories)
1 Pressand hold the learn button on garage door opener until the learn LED goes out
(approximately 6 seconds).
2 Immediately pressand hold the learn button again until the learn LED goes out. All codes are
now erased.
Reprogram any accessoryyou wish to use.
Remote Control