Champion 44 PRO - Rinse Arms

28
Cleaning
CLEANING
RINSE ARMS —
The upper and lower rinse arm nozzles should be cleaned regularly
to prevent scale build-up.
Rotate the rinse arm 1/4 turn and pull to remove from the rinse manifold, Fig. 73.
Inspect the red o-rings and replace if damaged, Fig. 74
1
Fig. 73 -
Rotate rinse arm 1/4 turn and pull to remove.
Fig. 74 -
Inspect o-rings and replace if damaged.
Rotate the rinse arm 1/4 turn and pull to remove from the rinse manifold, Fig. 73.
Inspect the red o-rings and replace if damaged, Fig. 74
Use a at blade screw driver to remove the rinse arm end plugs. FLush the rinse arm.
Inspect the end plug o-ring and replace if damaged, Fig. 76.
Use ne piece of wire and clean the rinse spray nozzles to ensure they are not clogged
with scale build-up, Fig. 75.
2
4
3
Fig. 75 -
Inspect o-rings and replace if damaged.
Fig. 76 -
Inspect o-rings and replace if damaged.
1/4 turn
Pull
o-rings
Rinse nozzle
Wire
End Plug
o-ring