Aeration Filter Master Programming
Regeneration Time (r)
After pressing the Menu/Enter and Set/Change Button, the display shows the option setting for Regenera-
Example: 12 A.M. regeneration time - [ r12A ] (Factory Setting for Filters)
To Adjust this Value Press the Set/Change Button.
To Accept the Digit Value Press the Menu/Enter Button.
Regeneration Cycle Step Programming
Press the Menu/Enter Button. The next 4 displays viewed are part of a series of option settings used to
program the Regeneration Cycle. Each display is used to set the duration time in minutes for that specif-
ic step in a regeneration cycle. A step # will turn on for the regeneration cycle step being programmed.
Regeneration steps are skipped by setting the display to 0.
Examples: Regeneration Cycle Step #2 - 10 minutes - [ 2 - 10 ] (Factory Setting)
Regeneration Cycle Step #3 - skipped - [ 3 - - 0 ]
25
To Next Page
Loading...