5.
PREPARATION BEFORE SEWING
5.
PR
PARATION BEFOR SEWING
5-1
. Installing the needle
• Turn
off
the
power
switch before installing the needle. The
motor
will keep turning even after the
switched
off
as
a result
of
the
motor's
inertia. Wait until the
motor
stops fully before starting
machine may operate if the treadle
is
pressed by mistake, which could result
in
injury.
Long
groove-
~
5-2.
R£~moving
the bobbin case
1.
Turn the machine pulley toward you to move the needle
bar to its highest position.
2.
Loosen the
screw(!).
3.
Holding the needle
(2)
with
its long groove facing
left
insert all the way into the needle bar.
4.
Tighten the
screw
CD.
• Turn
off
the power supply before removing the bobbin case. The motor will keep turning even after the
power
is
switched
off
as
a result of the motor's inertia. Wait until the
motor
stops fully before starting work. The
machine may operate if the treadle
is
pressed by mistake, which could result
in
injury.
2
-9-
1.
Open the bed slide.
2.
Pull the latch
CD
of
the bobbin case upward and then
remove the bobbin case.
3.
The bobbin
(2)
will come
out
when
the latch
CD
is
released.
From the library of: Superior Sewing Machine & Supply LLC
To Next Page
Loading...
Need help?
General
