8. STANDARD ADJUSTMENTS
8·~
13, Adjusting the feed regulator
-24-
If the stitch length
of
forward
and
reverse
are
not
same, make adjustment
of
feed regulator.
1.
Remove the arm rear cover plate
2.
Turn the cover plate
\{;;),
loosen the screw
with
holding upward the reverse lever.
3.
When the mark
of
feed regulator and feed regulator
rod
<5J
are
alignment, stitch length
of
forward
and
reverse
will
be
same.
4.
Turn feed regulator rod 0 to the arrow
"X"
, stitch
length
of
reverse is bigger and stitch length of forward
is
smoller.
5.
Turn feed regulator rod
(g)
to the arrow
"Y"
,stitch
length of reverse
is
smoller and stitch length
of
forward
is
bigger.
6.
After adjustment,tigthen the
screw
·JJ.
From the library of: Superior Sewing Machine & Supply LLC
To Next Page
Loading...
Need help?
General
