EN
8
DIRECTIONS FOR USE PATIENT
ELECTRODE SETUP
. Make sure unit is turned o and lead
wires are disconnected before and after
treatment.
. Clean electrode application area with
soap and water. Rinse and dry. Electrode
should only be applied to intact, clean
skin (e.g., not over open wounds, lesions,
infected, or inflamed areas).
. With electrodes still on liner, connect lead
wire from unit electrode connector. No bare
metal should be visible.
. Remove electrode from liner by grasping
the edge of the electrode and peeling it o
the liner. Retain liner for storage.
. Place the electrode on exact skin location
by applying the center of the electrode first
and smoothing down to electrode edges.
. Attach lead wire to unit and begin
treatment.
. After treatment, turn unit o.
. Remove electrode from skin by peeling
electrode edge.
. DO NOT place electrodes on broken skin.
If skin irritation develops, discontinue use.
Consult physician. Replace electrodes when
they do not adhere or when treatment
becomes uncomfortable.
. DO NOT use unit while driving or
operating machinery.
. For single patient use only. These
electrodes may be repositioned up to
several times on the same patient.
. Stimulation should not be applied
transcerebrally or over the anterior neck
region.
. Keep electrodes separated during
treatment.
. DO NOT remove electrode by pulling on
the lead wire.
. DO NOT exceed . Watts/cm.
. Using stimulation electrodes that are too
small or incorrectly applied could result in
discomfort or skin burns.
DIRECTIONS FOR USE PATIENT
To Next Page
Loading...
