EN
9
RE-APPLICATION AND STORAGE OF
ELECTRODES
• If adhesive becomes over-saturated, allow
electrode to air dry in a refrigerator with
adhesive side up until gel regains tack.
• If the electrode gel appears dry, add a few drops
of water to the electrode gel. Let rest to regain
tack and apply to skin.
• If electrode accumulates dirt/dust in the
adhesive, the impedance increases, usually
leading to increased heat dissipation at the
electrode which can lead to skin burns. Inspect
the electrode for dust and dirt accumulation
before reuse. Feel the electrode to make sure it
is still tacky. If the adhesive has accumulates too
much dirt/dust, it will no longer adhere. Replace
electrode when it does not adhere.
• Between uses (on the same patient), return
electrode to liner and store in resealable bag in
a cool place out of direct sunlight.
NOTE: The life of the electrode varies depending on skin
conditions, skin preparation, type of stimulation, storage,
and climate.
GETTING STARTED
Your kit will include:
• AA Batteries
• Belt Clip
• Carrying Case
• Electrodes and Touch proof Lead Wires Note:
Your electrodes have been specified by your
clinician as part of the prescription.
• Chattanooga Continuum Device
• Instruction Manual
• Remote hand switch
USING THE FRONT PANEL
Before you use the device, you should be familiar with the
location of the Soft Key control buttons, ON/OFF ( )
button, OK button and the Home button.
Simple Operational Procedure Steps
The front panel should appear as shown below.
. Press the ON/ OFF button ( ) located on the bottom
row, middle button.
You should first see the Chattanooga logo along with
software version number displayed on the LCD for four
seconds before displaying a therapy options menu as seen
below.
The device is now ready to function.
To Next Page
Loading...
