Chattanooga Continuum - Device Features and Maintenance

EN
11
OTHER FEATURES
Changing the Batteries
Change BOTH of the AA batteries when:
• The low battery indicator is visible on the LCD
• The Low Battery message displays
• If the device will not turn on.
Turn o the device to replace batteries.
Open the battery door by placing your thumb on the
notch and the bottom back side of the unit and pushing
up while pulling out.
When replacing the batteries, be sure the battery polarity
(+ and -) markings match the markings on the device.
Use AA alkaline or rechargeable NiMH batteries.
The life of the battery is dependent on the program and
amplitude (intensity) being used.
The battery use indicater may not show % power when
a fully charged rechargable battery is used; but the battery
life is still full.
To Replace the Battery Cover
. Insert the small lip at the base of the cover.
. Insert the top of the cover and press until it clicks
securely in place.
Using the Belt Clip
Chattanooga Continuum has a simple belt clip that fits
comfortably over a belt or waistband.
To attach the belt clip, simply face the back of the device
toward you and slide the device, with a gentle pull of the
clip tab. When in place, you should feel a slight tension
holding it in place.
Using the Kick Stand
Chattanooga Continuum has a simple, pull-out Kick Stand
for use in patient monitoring. To use the kick stand, turn
the device to the back side.
Placing your finger on the recessed tab, pull the stand out
for use.