Configuring through a web browser
35
For Reference Station Mode:
There are three modes available:
a) Auto Rover: The receiver will serve as a rover after this mode is enabled, and
then receive correction data through the working mode set last time.
b) Auto Base: The receiver will serve as a base after this mode is enabled, and
then broadcast correction data based on coordinate inputted by user, or
obtained through autonomous positioning automatically.
c) Manual Base: The receiver will serve neither as a base or a rover after this
mode is enabled. Users need to configure the receiver manually.
For Reference Latitude and Reference Longitude:
There are mainly three methods to enter the reference coordinates and shown as
follows:
a) Acquire Current Position: Click this button to acquire current position obtained
through autonomous positioning automatically.
To Next Page
Loading...
