CHCNAV i83 - Page 31

Front Panel Operation
CHCNAV i83 GNSS USER GUIDE
| 2022-01
P a g e |
30
The details of Data operations are as follows:
Top-level Menu
Second-level Menu
Description
Data
Set on/off
Press Enter button to switch static
measurement on or off.
Recording 00:00
Display the time of recording
Advanced
Sample
Press Enter to change sample interval
(1s, 2s, 5s, 10s, 15s, 30s, 1m)
Elev Mask 10
degree
Press Enter button to change the mask
degree from 0 degree to 90 degrees.
Duration
1440min
• Press Enter button to enter Duration
Time Setting screen.
• In the Duration Time Setting screen,
press Fn button to move to the
character of the duration time value
user want to make change, and then
press Enter button to change from 0 to
9. After the change has been done, user
can press Fn button to move to OK field,
and then Press Enter button to save the
change and back to the
second-level menu; or press Fn button
to move to Cancel field and press Enter
button to cancel the change and back
to the second-level menu.
Measurement
phase Center
Press Enter button and switch height
between oblique, vertical, phase
center.
Antenna
Height
0.0000m
Press Enter button and input the
measured antenna height.
Format HCN
Press Enter button and switch data
format between HCN, HRC,
Rinex2.11 and Rinex3.02.
Ok
Press Enter to complete settings.
Cancel
Press Enter button to back to the
last menu.
OK
Press Enter to complete settings.
Cancel
Press Enter button to back to the
top-level menu.