CHCNAV i83 - Configure the Working Mode

Front Panel Operation
CHCNAV i83 GNSS USER GUIDE
| 2022-01
P a g e |
31
3.2 Configure the Working Mode
7 workingmodes are provided for quickly setting up an RTK base station or rover station. Users
can configure each working mode through the front panel as follows:
Top-level Menu
Second-level Menu
Description
Base External
UHF
Mode Base External UHF
The title of this configuration
screen.
Format CMR
Press Enter to select correction
format (RTD, CMR, RTCMv2.3,
RTCMv3 and RTCMv3.2).
OK
Press Enter button to save the
settings and back to the top-level
menu, and then this working mode
can take effect.
Cancel
Press Enter button to cancel the
settings and back to the second-
level menu.
Base Internal
UHF
Mode Base External UHF
The title of this configuration
screen.
Protocol CHC
Press Enter to select current
protocol (CHC, Transparent,
TT450s)
Channel 1 456.0500
Press Enter to change the channel
from 0 to 9
Baud 9600
Press Enter to select Baud (4800,
9600 and 19200)
Power 1w
Press Enter button to change the
transmitting power (0.5w,1w,2w).
Format CMR
Press Enter to select correction
format (RTD, CMR, RTCMv2.3,
RTCMv3 and RTCMv3.2).
OK
Press Enter button to save the
settings and back to the top-level
menu, and then this working mode
can take effect.
Cancel
Press Enter button to cancel the
settings and back to the second-
level menu.