www.chenbro.com
11
ES34069 Chassis User’s Manual Rev. A1
Installing 3.5” SATA-II Hard Drive
1 2
3 4
3 4
■ Remove the HDD Carrier from the chassis and place
the SATA-II HDD into it.
■ Attach the HDD screws on both sides
■ Slide in the assembled HDD into the chassis, suggest
install by the ID definition on the front panel
(No need to remove the front bezel)
■ Make sure the carrier is fully seated
■ Slide the assembled CD-ROM into the chassis
■ Make sure the holder latch is secured when fully
seated
To Next Page
Loading...
