Need help?Do you have a question about the Chenbro RM238 Series and is the answer not in the manual?
Provides a high-level overview of the system's features and available options.
Details the components and layout of the front panel, including controls and indicators.
Describes the components and layout of the back panel, including power supplies and expansion slots.
Explains the functions of buttons, LEDs, and connectors on the front control panel.
Illustrates various front drive bay configurations supported by the RM238 series.
Provides detailed physical dimensions of the chassis for installation and rack mounting.
Details the available slide rail kits and their specifications for rack mounting.
Defines the operating and non-operating environmental parameters for the system.
Describes the system packaging information, including product weight and testing standards.
Provides step-by-step instructions for removing and installing the top cover of the chassis.
Details the process for removing and installing the main HDD cage assembly.
Explains how to remove and install 3.5-inch hot-swap HDD assemblies.
Instructions for removing and installing 3.5-inch HDDs using tool-less methods.
Procedure for removing and installing 3.5-inch HDDs using screws.
Details the procedure for removing and installing 2.5-inch hot-swap HDD assemblies.
Steps for removing and installing 2.5-inch HDDs using tool-less methods.
Instructions for removing and installing 2.5-inch HDDs using screws.
Details on installing 2.5-inch HDDs into 3.5-inch drive trays.
Procedure for removing and installing internal 2.5-inch HDDs within the chassis.
Instructions for removing and installing the slim optical disk drive (ODD).
Procedures for removing and installing the entire system from/into a rack.
Detailed steps for removing and installing the fan assembly units.
Instructions for removing and installing individual fan modules.
Procedure for removing and installing the chassis air baffle for cooling.
Details the installation of a 2.5-inch 2-bay drive cage on the back panel.
Instructions for installing the drive backplane to the rear of the drive cage.
Steps for installing full-height PCIe cards, including riser card and bracket.
Procedure for installing and removing the Power Supply Unit (PSU).
Details on assembling and installing the redundant PSU cage.
Instructions for installing and removing the Common Redundant Power Supply (CRPS) module.
Step-by-step guide for installing the slide rail kits for rack mounting.
Lists the various storage backplanes supported by the RM238 series.
Specifications and features of the 3.5-inch 8-port passive Mini-SAS HD backplane.
Specifications and features of the 3.5-inch 12-port passive Mini-SAS HD backplane.
Specifications and features of the 3.5-inch 12-port active Mini-SAS HD backplane.
Details the accessory kit for mounting two 2.5-inch SATA or NVMe SSDs.
Specifications for the 2.5-inch 8-port passive Mini-SAS HD backplane.
Specifications of the 2.5-inch 16-port SAS backplane docked with an expander board.
Specifications for the 2.5-inch 8-port backplane supporting SATA, SAS, and NVMe.
Specifications for the 2.5-inch 8-port backplane supporting PCIe Gen3 NVMe drives.
Procedures for handling products found defective upon arrival.
Outlines the steps for returning products for repair or replacement.
Provides contact details and information required for technical support.
To Next Page
General
