www.chenbro.com
20
ES34069 Chassis User’s Manual Rev. A1
2-port SATA-II Backplane Introduction
ES34069 is integrated with two SATA-II backplanes to support four 3.5” HDD
hot-swap feature. With dedicate backplane bracket assembled, users can directly
attach the HDD on the tray and plug into the HDD slot.
Hardware Specification:
Part Number 80H104534-001 Rev. A1
Host Interface SATA 7-pin compatible
HDD Interface SAS (22+7), SATA-II compatible
Hot-Swap Yes, allows user to on line replace Hard Disk Drive
Connectors
1. SATA-II x2 (to Host)
2. SAS (22+7) x2 (for HDD)
3. Standard 4P Power connector x 1 for +5V, +12V from
power supply
Dimension 232(L) x 27.4(W) x 1.6(T) mm
Backplane Connectors
(1) [CN11/CN21] : “22+7”pin SAS Connectors to HDD
(2) [CN22/CN12] : SATA Connectors to Host
(3) [CN1] : 4-pin Power Connector
(4) [CN3] : HDD Access LED Signal Pin Header
(5) [CN4] : HDD Failure LED Signal Pin Header
Connecting Pin 1 & 2 to the CATHODE of the HDD failure connector on RAID
card. Refer to the RAID card’s user manual for the detail pin definition.
CN4
CN22
CN1
CN11 (HDD 1)
CN12
CN21 (HDD 2)
CN3
To Previous Page
Loading...
