Chenbro ES34069 - Connecting Devices; Connecting SATA-II Cables; Connecting Power Cables

www.chenbro.com
15
ES34069 Chassis User’s Manual Rev. A1
Connecting Devices
ES34069 is pre-installed with several cables inside as factory default,
which includes:
z SATA-II cable for Hot-swap hard drive
z Power cable for M/B
z Front panel I/O cables
 USB 2.0 cable
 4-in-1 card reader
Connecting SATA-II Cables
Note: If there is no enough SATA port on M/B, users can either remove or keep the
bundled P3/P4 SATA cable.
Connecting the Power
1 2
1 2
■ Check the bundled cable with number tag ■ Connect the SATA cables to the M/B properly
■ The DC harness comes with 20+4 pin as main
connection for different M/B requirement.
■ Install and secure the DC harness cable to the M/B
properly
■ Secure the heatsink clipper in another end