Cheyenne HAWK - Preparing the Tattooing Machine for Use; Disinfecting Equipment

39
Cheyenne HAWK, HAWK SPIRIT & HAWK THUNDER
5 Preparing the tattooing
machine for use
ATTENTION
Damage from condensate
If your tattooing machine is exposed
to significant variation in temperature,
e.g. during transport, condensate
can form inside which can damage
theelectronics.
E Ensure that your tattooing machine
has reached ambient temperature
before using it. If it was exposed to
high temperature fluctuations, wait
for at least 3 hours for every 10°C
of temperature dierence before
putting it into operation.
E Only use your tattooing machine
at ambient temperatures of +10
to +35°C.
5.1 Disinfecting equipment
ATTENTION
Damage to drive caused by fluid
If disinfectant gets inside the drive,
this can corrode the electrical and
mechanical components.
E Never immerse the drive in disinfectant.
ATTENTION
Product damage caused by non-
approved disinfectants
Disinfectants that are not compatible
with the materials of the product can
damage its surface.
E Always use disinfectants that are
approved, i.e. that comply with
stipulations in your country.
E Note the list of recommended dis-
infectants in chapter “7.1 Material
compatibilities” on page47.
E Switch o the power supply to your
tattooing machine.