Cheyenne HAWK - Replacing the Safety Cartridge

43
Cheyenne HAWK, HAWK SPIRIT & HAWK THUNDER
E Connect the connecting cable sup-
plied in the scope of delivery to a
Cheyenne Power Unit to supply your
tattooing machine with power.
E Cover the power unit or the third
party power unit with a protective
film.
5.5 Replacing the safety cartridge
WARNING
Risk of injury from needles
Injuries caused by contaminated
needles from the safety cartridges
can lead to the transmission
ofdisease.
E Only use original Cheyenne
safety cartridges. The installed
safety membrane on these safety
cartridges prevents the ingress
of ink into the drive, and also
prevents pathogens from entering
the appliance through the safety
cartridge.
E Never hold the safety cartridge by
its tip or the bayonet connector.
E Switch o your tattooing machine
before changing the safety
cartridge.
E Ensure that when removing a used
safety cartridge, no ink remnants
can run into the handle.
E Never push the needles out of
thesafety cartridge by hand.
E Check during the removal of a used
safety cartridge that the needles
are completely retracted into the
safety cartridge.
E Dispose of used safety cartridges
that are no longer required for
thecurrent application (see chapter
“9 Disposal of equipment” on
page49).