Chiltrix Inc. www.chiltrix.com
(4) Shutdown button: Used to execute the shutdown command, when clicked it will pop up a confirmation
window, click "OK" to execute the boot command, or click "Cancel" for no action.
The shutdown command us used to take the chiller out of heating or cooling mode.
(5) Defrost: Is illuminated when system is in the Defrost State.
(6) Antifreeze: Is illuminated when system is in the antifreeze mode.
(7) Sterilization: Is illuminated when system is in the sterilization mode.
(8) Ground source heat pump: N/A
(9) Compressor：Illuminated when the compressor is on.
Standard Controller (cont’d)
Figure 1-2
(10) AC temp setting: Temperature setting in the air conditioning mode (cooling or heating), touch the “SET
TARGET TEMP” icon and the keyboard window will pop up, as shown in Figure 1-2, then, enter the
required temperature. Use the ENT" key will confirm the input. Use the "DEL" key to delete the input,
and the "ESC" to cancel the input and exit.
(11) DHW temperature setting: Sets the temperature in the (DHW) mode.
(12) AU heat: Not used, please disable unless using Dynamic Outdoor Reset (P. 57).
(13) AU DHW: Not used, please disable.
(14) Current DHW temperature: This is used to check the current DHW mode temperature.
(15) Fault light: Illuminated if there is a fault.
31
To Next Page
Loading...
