5.2 To Install GO with a Base Unit
Installing and pairing GO with a Chiptech base unit (with or without a Pearl pendant) requires a
few extra steps as set out below:
1. Start by installing the base unit as per the standard installation procedure in the Chiptech
EVE, EVA or SEVEN Installer Manual.
2. Once installation and testing of the base unit has been completed, follow Steps 1 to 4 of the
GO installation process as above (section 5.1)
Do not perform a System Check at this point.
3. Enter ‘Learn Mode’ on the Chiptech base unit. You will be asked to press your pendant(s) or
RF device(s). Please re-learn in any Pearl or other RF devices now, before learning in GO.
Learn all devices in the one session.
4. To learn GO, press and hold both buttons at the same time for one second, and the base
unit will announce that a new pendant has been learned. The GO pre-alarm will begin, and
this will need to be cancelled at this point by holding one of the buttons for one second. GO
will announce, “Cancelled”.
5. GO will now be learned in. Cancel ‘Learn Mode’ by pressing the cancel button on the base
unit once.
Now that GO has been successfully learned into the base unit, you can demonstrate the System
Check (Section 4) and Requesting Help (Section 2)) for GO. Check with monitoring that the GPS
report says ‘Home’, instead of giving GPS co-ordinates which should only happen when out of the
range of the base unit.
• If GO is activated while within range of the Chiptech base unit, the emergency alert will still be
sent through GO. This means that there will be no pre-alarm played from the base unit and
monitoring will call the user back on the GO.
• GO will send a ‘Home’ report instead of the GPS co-ordinates through to SmartCare Locate (a
purpose-built website application), or mapping software, to confirm that the GO is in range of
the base unit.
Sending an alert via the Chiptech Base Unit:
As a backup, if GO for any reason is unsuccessful in sending an alert after a round of attempts,
GO will send another alert to the base unit. Once confirmed by the base unit, it will take over the
event and send the activation through to monitoring.
To Next Page
Loading...
