23.3 GPS
Q. Why is my GPS location not accurate?
A. There are a few factors that can affect the accuracy of the GPS location, the most common
are buildings and surrounding structures. GPS is best obtained when you have line of sight to
the satellites. If you send GPS locations from GO inside a building or in a city centre with tall
buildings, this can affect the accuracy of the GPS reports.
23.4 Flight Mode
Q. How to enter into Flight Mode
A. To enter flight mode, press and hold one button on either side of GO for 10 seconds until
you hear the voice announcement, “Flight Mode enabled. All functions suspended until
button press, or placed on a charger.”
Q. How to get out of Flight Mode
A. Either perform a System Check, or place GO on a charger.
Q. Do you need to exit Flight Mode before you can use GO?
A. Flight Mode will automatically disable when the user performs any button press, System
Check or activate an alert.
Q. Will GO work in different countries?
A. No, GO will only function in the country it has been setup to operate in. It will only function
on the installed SIM card and network(s) it has been setup to use. Please contact
support@chiptech.co.nz for specific SIM details.
23.5 GO paired with a Chiptech Base Unit
Q. Does GO work with my Chiptech Base Unit?
A. Yes, GO can be learned into any Chiptech EVE variants. To learn GO into a Chiptech base
unit, refer to the Installer Manual for the relevant base unit.
Q. Do you perform a Range Test with GO?
A. There is no need to perform a range test with GO. However, to ensure there is adequate
cellular coverage please perform a System Check in any area where you think GO may need
to be used to send an alert.
To Next Page
Loading...
