CHIYU TECHNOLOGY CO., LTD.
No.28, Renai Rd., Chiayi, 600, Taiwan Tel：(886) 5-2835460 Fax：(886) 5-2835458
BF-480M User’s Guide
- 16 -
Close Connection when Idle Time Over (second)
Setting Factory Default Necessity
0 to 65535 seconds 0 Required
If you want to keep the connection always on between BF-2300 and your ISP, then set the value of item Close
Connection When Idle Time Over to 0, otherwise, when the idle time of no any traffic on line is over the setting
value, BF-2300 will terminate this PPPoE connection.
PPPoE with Fixed IP Address
Setting Factory Default Necessity
Disable/Enable with IP address xxx.xxx.xxx.xxx Disable Required
If your ISP can provide you fixed IP address when PPPoE connection established each time, you can select
PPPoE with Fixed IP Address as ENABLE and enter the IP address given from ISP.
3.2 Networking Operation mode
The BF-2300 support three operation mode: TCP Server, TCP Client, UDP . These modes are listed in the
drop-down menu for the Operation Mode setting. Each setup screen and available features will differ depending
on what kind of operation mode you select. Default is TCP Server.
TCP Server
To Next Page
Loading...
Need help?
General